Hi all, back with a small update.... On leave a few days, so can chiong a bit of plastic=)
Ok, the other day Link was asking about the adding on of the extra pla plates to the skirt, so today I'll show how it's done.... Nothing much really, but just share share so everyone can learn learn...
So first you select the area you wanna place the detail..... In this case the lower area of my Nu's KKJ area..... ( I'm sure you know what KKJ is....O.o)
So you cut pla plate to desired shape and cement it. Please note to cut pla plate BIGGER than the actual surface area... Next you sand off the excess til it alights with the kit
Before
After
Ok now the take the next pla plate and place it on the other side that will form the erm.... full detail? Once again pla plate should be bigger than actual surface area. This time though you sand till it alighs the first pla plate you cemented earlier!!!
Now if you added enough cement earlier on it would have melted the 2 pla plates together to a point no seamline can be noticed, so spray surfacer to make sure.As seen here I used super glue+baby powder combo to seal the line.... Sand off and check again to make sure and Vola detail UPPPPP!!!
Here is the front KKJ area and back A$$hole and skirt area done up..... Phew, Burning out liao...... HELLLPPPPP!!!!!
KKJ
2 comments:
With the right efforts and your enthusiasm, I hope this will give you some happiness in your life, apart from the hum-drum of your work.
Model making is the only way I can have fun and relax.... Thanks dude....=)
Post a Comment